CCNA · Free Practice Question Medium
Question 7
Refer to the exhibit.
A network administrator is troubleshooting a connectivity problem on the serial interfaces. The output from the show interfaces command on both routers shows that the serial interface is up, line protocol is down. Given the partial output for the show running-config in the exhibit, what is the most likely cause of this problem?
-
A
The MTU is incorrectly configured.
-
B
The Layer 2 framing is misconfigured.
-
C
The IP addresses are not in the same subnet.
-
D
The serial cable is bad.
Reveal correct answer
Correct answer: B
Discussion
Think the marked answer is wrong, or have a better explanation? Share it below — comments appear after review.
You must be logged in to post a comment.
